Now is the time when spring is slowly turning to summer, and the amount of rain has increased significantly. When using outdoor lighting led street lights, it is necessary to ensure that its waterproof performance is good. If the waterproof work of the led street lamp is not done well, the led street lamp will not light up and a short circuit will occur. In severe cases, rainwater enters the inside of the lamp holder of the led street light, corrodes the internal wires, makes the wires contact with the light pole, and affects people's safety. Therefore, it is necessary to do a good job of waterproofing LED street lights. Led street lights are mainly composed of street lamp poles and led street lamp heads. The street lamp poles are generally made of integral hot-dip galvanizing and plastic spraying treatment, which will not leak water. LED street lamp manufacturers and wall washer manufacturers need to pay attention to the waterproofing of the lamp holder of the LED street lamp. Only the waterproof work of the lamp holder can ensure the stability and safety of the LED street lamp lighting at night. Next, Zhongshan Yueyao Lighting Technology Co., Ltd. will tell you how to do a good job of waterproofing LED street lights.

       The sealing of the lamp cap must be passed, and the waterproof treatment of the lamp cap can ensure the service life of the street lamp. Therefore, the choice of the shell of the street lamp is very important. When choosing, you must pay attention to whether the style is waterproof. When installing the controller, it is generally placed inside the road, so as to better avoid wind and sun. It is necessary to have a certain degree of waterproof performance. For the installation of the battery, the battery is buried under the ground, about 40 cm, so as to avoid flooding. Afterwards, the led street lamp head should be tested to see if the street lamp is normally lit, if it is lit, it can be used normally, and if it cannot, it needs to be replaced.

 LED street light chips and lenses must consider their waterproof performance, and they must reach the IP65 level. The rear cover of the street lamp head, the rear cover of the power supply box, and the threading hole in the power supply box are respectively designed with a waterproof rubber strip and a waterproof plug with good sealing performance.

       It is necessary to do a good job in the aging detection of the lamp holder of the led street light. The waterproof rubber strip at the internal joint of the led street lamp has a service life, and the sealing performance of the joint may decrease after a few years. Therefore, manufacturers of high-power wall washer must perform aging testing after production to test their waterproof performance to ensure that the waterproof performance is good for at least 5 years.

       Based on the demand for waterproofing, flip-chip LED street lamp modules have been launched on the market. This type of module has the advantage of miniaturization, which is more advantageous for waterproofing. Because of its small size, the lens area is reduced, and the number of screws required is greatly reduced, thereby reducing the difficulty of waterproofing.