What problems and details should be paid attention to when installing LED display? Here is a graphic guide on the installation process of the LED display.

1. First, splice the cut profiles, that is, assemble the outer frame of the display screen. The general profiles on the market are nothing more than square or round, but the assembly method is the same.

2. After assembling the outer frame, place the P10 unit board in the frame (pay attention to the front and back of the frame, and the grooved side is the front). At this time, the position of installing the back strip is quite accurate, avoid the wrong one and change it. All the trouble.

3. After the back strip is fixed, remove the frame and install the magnet, as shown in the figure below:

4. Fix the unit board

5. Connect the flat cable, the upper and lower power cables

6. Fix the power supply of the display screen and the LED control card, the connection between the LED control card and the power cord. Connect the power cord of the LED control card to the nearest unit board, and the positive and negative poles are marked on the control card

7. Wiring the display power supply and the display unit board, pay attention to the positive and negative poles. It is recommended to use SVV2*1.0 soft core wire, that is, the main power supply of 1 square double-strand soft core wire is selected according to the size of the screen.

8. Connect the control card and the unit board cable (especially important). Please read carefully before connecting to understand that the screen is not fixed on the wall. This is the most critical step. You can check whether the screen is installed correctly by using the test button.

9. Data cable (usually use super-category 5 network cable for short distance) Normally, serial port 2, 3, 5 crossover cable is used, and parallel cable is also available. Wiring instructions are generally available on the software CD.