time:2021-08-06 source:ZJ Lighting Views:270
1. First, apply a little thermally conductive glue on the intact aluminum substrate, which can assist the wall-washing radiator to dissipate heat, and then solder the lamp beads one by one.
2. Install the wall-washing shell on the welded lamp bead board, and seal the two slots next to it. It is convenient to not leak the glue when filling the glue
3. What needs to be glued is to fill the slot of the LED wall washer carefully with silicone (white glue or black glue) that is easier to dry. The glue can also be used for waterproof and heat dissipation.
4. After the silica gel is dry, check carefully whether the lamp beads are covered by the glue, and clean it if there are some.
5. It is to cover the panel glass of the LED wall washer, and then install the assembly head. This is how the LED wall washer is manufactured. (Before the assembly header, these wires must be connected in the assembly header)
6. The last link is aging packaging
1. Illumination of identifying objects
Lighting for places that need space restriction and guidance, such as road pavement, stair steps, emergency exits, safe passages, etc. are widely used, low-voltage lighting, no glass and other fragile materials, energy saving and electricity saving will not increase the cost. It is worth promoting in areas such as iconic traffic safety guidance.
2. Use of indoor space lighting work
The use of high-power wall washer lighting will not generate a lot of heat, ultraviolet and infrared radiation, and will not damage the human body and commodity exhibits. The lighting system is simple and does not require additional filter devices. It is easy to install and accurate in lighting, suitable for exhibitions. , Museum and other indoor space lighting work.
3, outdoor landscape lighting
Because the high-power wall washer can be well integrated with the urban landscape, it can have good lighting effects in leisure spaces such as urban paths, decks, waterfront areas, and gardening areas. Concealed high-power wall washer lamps are especially popular, with plug-in fixed end design, which is convenient for height adjustment.
4, building exterior lighting
Projecting a certain area of the building. Because the high-power wall washer light source is small and thin, the research and development of linear projection has become a major advantage. The installation is convenient, and it can be installed horizontally or vertically, providing a wider range of night lighting design. The space is generally used for the lighting of modern and historical buildings.