Installation steps and requirements of high bay lights

　　Industrial and mining lamps refer  the general term of lamps used in facries, mines, warehouses, and high-bay production areas. In addition  various lighting lamps used in normal environments, there are also explosion-proof lamps and anti-corrosion lamps used in special environments. light. Because different environments will change the reflection efficiency of the lamps, we need  determine the installation height according  the specifications of the lamps and the specific lighting environment before the high bay lamps are installed.

　　Installation steps of LED high bay light (hoisting)

　　1. Set the hook in advance where the high bay light needs  be installed. It should be noted that the hook should be used in conjunction with the hoisting ring, and the load-bearing capacity of the hook must exceed 30Kg when installing the hook.

　　2. Clip the ring on the LED high bay light in the set hook, and hoist the lamp through the ring;

　　3. Connect the power cord from the scene  the power cord of the lamp, connect it according  the wiring principle of the lamp, and do a waterproof and insulating treatment;

　　4. After turning on the power, observe whether the LED high bay light can work normally, and after confirming that the light is on, the installation is completed.

　　Installation requirements for LED industrial and mining lamps

　　1. First, check the integrity of the LED high bay light and complete accessories.

　　2. When installing or replacing the LED high bay lights, be careful  disconnect the power supply first. When connecting the power supply, pay attention  the adaption of the input voltage and the industrial and mining lamp. After the power cord is connected, be sure  do the corresponding waterproof and insulation treatments.

　　Interstellar series (LED high bay light)

　　3. The wires on the LED industrial and mining lamps can be passed through the drilled holes and the wires behind the lamps can be fixed with wire clips  ensure firmness.

　　4. Note that the power cord of the lamp must be of sufficient length and not subject  tension or tangential force. Avoid excessive tension when installing the connection of the lamp, and the connection should not be knotted. Pay attention  distinguish the output connection and do not confuse it with other lamps.

　　Brilliant series (LED high bay light)

　　5. The distance between the product and flammable materials should be at least 0.2m, and the zenith  be installed should have a gap of 2 cm. The lamps should not be installed inside the zenith or on the wall with a heat source. Pay attention  low pressure and high Piezo wires are routed separately.

　　6. When installing the LED high bay light, please handle it with care. Do not drop it randomly and cause damage  the light. Strictly follow the installation instructions required by the manufacturer.

　　Heike Series (LED Graphene High Bay Light)

　　7. After the installation is completed, check the place  see if there are any blind spots in the lighting, and ensure that the lighting of the lamps meets the requirements.

　　Previous page

　　Previous post: Lighting requirements for pharmaceutical clean rooms/purification workshops

　　Next: What is the potential of linear lighting in industrial and office spaces? "